Anker SOLIX C800 Plus Specs: 768 Wh (60 Ah), 1,200 W

The Anker SOLIX C800 Plus is a beginner tier unit in the under $1,000 budget band. The camping variant of the C800, which ships with a light bar and pole storage built into the case. Same 768Wh and 1200W inverter, with a 58 minute wall charge.

This unit sells mainly direct and through dealers rather than through a consistent Amazon listing, so the link above opens a scoped search rather than a specific product page. That is the honest output: inventing a product code to make the card look complete would send you to the wrong thing.

Who is the Anker SOLIX C800 Plus for?

Tent and rooftop-tent campers who want the station to do double duty as camp lighting.

And, just as usefully, who it is not for: fixed van installs, where a light bar in the lid is dead weight and a wired 12V circuit is better.

Beginner tier here means a unit sized for weekends and device charging, where the fridge is either small or absent and the vehicle is doing most of the charging. It is where almost everyone should start, because a season with a small system teaches you what you actually run.

What are the full Anker SOLIX C800 Plus specifications?

The spec table at the top of this page is the maker's published specification. Rows we could not confirm are left out entirely rather than filled with a guess, because a precise looking invented number is worse than a visible gap on a purchase this size.

The capacity conversion is worth understanding because the whole 12V world is quoted in amp-hours while power stations are quoted in watt-hours. Amp-hours equal watt-hours divided by voltage, so 768Wh at a 12.8V LiFePO4 nominal is about 60 amp-hours. That is the number to compare against a wired battery, and it is how the battery bank calculator works.

How long does the Anker SOLIX C800 Plus run real loads?

Runtime is capacity divided by average draw, and the word doing the work there is average. A compressor fridge's rated wattage is what it pulls while the compressor is spinning, and in a 90F vehicle it spins roughly 40 percent of the time. The daily figures below are averages rather than nameplate ratings, which is why they are much lower than the numbers printed on the appliance.

Real trips run several of these at once, so add them rather than reading one row. A fridge in heat plus a laptop plus phones plus lighting comes to about 840 watt-hours a day, which is the figure most two person builds land on. Work out your own total with the power consumption calculator, and see how a fridge's draw moves with ambient temperature on the fridge power draw chart.

How much solar does the Anker SOLIX C800 Plus need?

Daily solar return is panel watts multiplied by peak sun hours multiplied by a derate factor that covers heat, angle, cable loss and controller efficiency. Three quarters is a fair derate for a well mounted array with MPPT tracking. The table assumes five peak sun hours, which is a good summer day across most of the continental United States.

The input ceiling matters more than the panel rating. This unit accepts at most 300W, so anything above that is capability you paid for and cannot use. Size the array to the ceiling, then check the numbers for your own latitude on the sun hours by region chart and the solar array calculator.

What does the inverter actually cost you in battery current?

This is the part that surprises people moving from a station to a wired system. DC current equals AC watts divided by system voltage times efficiency, so this unit's 1,200W inverter is pulling roughly 111A from its internal 12V battery at full output. Inside a sealed station that is the manufacturer's problem, and every cable and fuse for it is already fitted.

Build the same capability yourself and it becomes your problem: that current sets the cable gauge and the fuse rating, and getting it wrong is the most common way a DIY 12V build becomes a fire. If you are comparing this unit against a wired inverter, run the numbers through the inverter sizing calculator and the wire gauge calculator first.

How does it compare with the rest of the Anker range, in amp hours and run time?

What else sits in the same tier?

Cross-brand alternatives at a similar capability and price. Compare cycle rating and solar input ceiling as carefully as capacity, because those two decide how the unit behaves over years rather than over a weekend.

Should you buy this, or wire a battery instead?

The honest comparison is not capacity, it is charging speed and responsibility. A sealed station takes roughly 100 to 150W from a vehicle 12V socket. A wired DC-DC charger takes 600W or more straight off the alternator, which means the same two hour drive refills four times as much. That single number is why long trips push people toward a wired system and why weekends do not.

What a station buys instead is that nothing is cut, drilled or crimped, and that the fusing, the charge controller and the inverter are already inside the case and already correct. For a first system that is genuinely the safer choice. The full argument, with costs on both sides, is on power station versus DIY battery bank, and the finished versions of both are on the beginner build and the intermediate build.

Where to go next

Compare this unit against the full field on the best portable power stations, browse every unit we have specifications for in the power station index, or work out what you actually need first with the power consumption calculator.